Brooklyn since 2014All five boroughsSame-day response during business hours

What is NYC MC § 506.3.2.1?

Quick Answer

This section specifies the types of duct joints permitted in construction, including butt joints, welded flange joints, and overlapping duct joints. It outlines installation requirements to prevent grease accumulation and ensure proper drainage. Applies to building owners involved in HVAC system installations.

General informational summary. Not legal advice for your situation. Consult an attorney before acting on any specific matter.

Michael Nacmias - Founding PartnerMichael Sargo - Partner
From the team atNacmias Law Firm, PLLCBrooklyn-based attorneys representingproperty owners across all five boroughsMeet the team →

506.3.2.1 Duct joint types.

MC § 506.3.2.1

Duct joints shall be butt joints, welded flange joints with a maximum flange depth of 1/2 inch (12.7 mm) or overlapping duct joints of either the telescoping or bell type. Overlapping joints shall be installed to prevent ledges and obstructions from collecting grease or interfering with gravity drainage to the intended collection point. The difference between the inside cross-sectional dimensions of overlapping sections of duct shall not exceed 1/4 inch (6.4 mm). The length of overlap for overlapping duct joints shall not exceed 2 inches (50.8 mm).

Common Questions

Our team

Meet the people you will work with

Free case review

Have a matter that touches § 506.3.2.1?

Free 15-minute case review with the attorney handling your matter. Same-day response during business hours across all five boroughs — OATH hearings, Housing Court, and real estate closings.

Or email us

[email protected]

An attorney reads every message.

  • Same-day response

    During business hours

  • Direct attorney access

    Same lawyer from intake to close

  • Flat-fee pricing

    On most OATH and closing matters