Brooklyn since 2014All five boroughsSame-day response during business hours

What is NYC MC § 1210.6.6?

Quick Answer

This section establishes the requirements for joints between polyethylene plastic pipe and tubing or fittings used in ground-source heat pump loop systems. It specifies that joints must comply with designated standards for heat fusion, electrofusion, or stab-type insertion. Applies to contractors and installers of ground-source heat pump systems.

General informational summary. Not legal advice for your situation. Consult an attorney before acting on any specific matter.

Michael Nacmias - Founding PartnerMichael Sargo - Partner
From the team atNacmias Law Firm, PLLCBrooklyn-based attorneys representingproperty owners across all five boroughsMeet the team →

1210.6.6 Polyethylene plastic pipe and tubing for ground-source heat pump loop systems.

MC § 1210.6.6

Joints between polyethylene plastic pipe and tubing or fittings for ground-source heat pump loop systems shall be heat fusion joints complying with Section 1210.6.6.1, electrofusion joints complying with Section 1210.6.6.2, or stab-type insertion joints complying with Section 1210.6.6.3.

Common Questions

Our team

Meet the people you will work with

Free case review

Talk to an attorney before you act on NYC code.

Free 15-minute case review with the attorney handling your matter. Same-day response during business hours across all five boroughs — OATH hearings, Housing Court, and real estate closings.

Or email us

[email protected]

An attorney reads every message.

  • Same-day response

    During business hours

  • Direct attorney access

    Same lawyer from intake to close

  • Flat-fee pricing

    On most OATH and closing matters